Anritsu MG3692A High Performance RF/Microwave Signal Generators 2 to 20 GHz

Anritsu MG3692A High Performance RF/Microwave Signal Generators 2 to 20 GHz
 
The Description of Anritsu MG3692A RF/Microwave Signal Generators

Features of  Anritsu MG3692A RF/Microwave Signal Generators

■ Six base models

- MG3691A 2 to 8.4 GHz

- MG3692A 2 to 20 GHz

- MG3693A 2 to 30 GHz

- MG3694A 2 to 40 GHz

- MG3695A 2 to 50 GHz

- MG3696A 2 to 65 GHz

■ Resolution - 0.01 Hz

■ Phase Offset - 0.1 dB steps

■ RF Frequency Coverage Extension, down to 0.1 Hz

- Best solution for dual RF and Microwave applications

- An optional down-converter covers 10 MHz to 2 GHz

- An optional DDS offers additional coverage to 0.1 Hz!

■ Excellent Phase Noise performance as standard - Add optional ultra low phase noise > 2 GHz

- Add an optional digital down-converter for:

- Lowest Phase Noise RF source from 10 MHz to 2.2 GHz

- < 130 dBc/Hz @ 1 GHz, 10 kHz offset

■ High Output Power - 13 dBm standard (@ 20 GHz)

- 17 dBm optional (@ 20 GHz)

- 14 dBm optional (@ 40 GHz)

■ Wide Attenuation Range - 110 dB Mechanical Attenuator Option

- 120 dB Electronic Attenuator Option

■ AM/FM/ØM/PM, External or Internal

- 100 ns leveled pulse width >2 GHz, 1 µs <2 GHz

■ IF Up-Conversion Option

- Obtain IQ-modulation microwave signals by up-converting a modulated IF signal​

External multipliers can be added to the MG3690A to provide coverage as high as 110 GHz. Please call us for solutions beyond 110 GHz.

The 54000 series multipliers provide 50 to 75 GHz coverage in WR15 or 75 to 110 GHz in WR10. An MG3690A with Option 18, mmW bias, is required to drive these multipliers. The MG3692A provides the input frequencies which are below 20 GHz. Higher frequency MG3690A models could be used, but are not necessary. Option 18 adds a rear panel BNC Twinax connector that supplies the proper DC bias to power these external multipliers. (Option 18 is not available with Option 7.)

The 54000 series multipliers come in two versions, –4 and –5. Both versions include input and output isolators for improved source match. An external full-band “Through” (FL1) can be replaced with either one of two split-band supplied external filters (FL2, FL3) for better than –50 dBc spurious. The –5 version adds an internal output coupler and a detector to supply a detected voltage output. This output can be routed to the synthesizer’s external ALC input for a flatter response, using External ALC Leveling mode.

Modulation can be used up to 110 GHz with these multipliers. FM/ΦM’s deviation will be multiplied based on the multiplication factor of the 54000 used. Pulse Modulation is available, with sharper rise and fall times. AM is not recommended. All performance is typical.

Order Information